Caterham Seven Manuel d'utilisateur Page 206

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 227
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 205
Page | 205
17.0) Options
These fitting instructions are supplied in
addition to the normal assembly guide
delivered with your kit. They are specific
to the additional equipment required when
using your car for competition purposes.
This document is supplied with new kits
and as instructions to customers
purchasing upgrades for an older car. IVA
notes have been included for customers
needing to register a new vehicle.
It is important that these instructions are
read in conjunction with your assembly
guide in particular with regard to the
preliminary information that can be found
at the front of the guide.
17.1) Battery master switch
If specified the battery master switch will
have been fitted at the factory.
Locate the two thick red leads exiting the
transmission tunnel. Connect the lead
marked 'starter' to the starter solenoid
along with the large brown lead (with
black sleeve) from the alternator. Route
the lead marked 'battery' to the battery
positive terminal. Do not connect.
Check that the lead to the battery is
attached to the single connection of the
master switch and the lead to the starter is
attached to the master switch connection
along with a double brown wire.
17.2) Standard roll over bar
Insert the bosses; on the underside of the
roll over bar main hoop into the bucket
bushes located at each end of the seat
belt header rail towards the rear of the
cockpit, refer to Figure 181. Locate the
rear diagonals of the roll over bar into the
mounting brackets at the rear of the boot
compartment. Secure the roll over bar to
the chassis using set screws (fastener
pack 30P010A Item 2), spring washers (6)
and washer (5).
The rear diagonals are secured to the
brackets by bolt (1) and nyloc nuts (4) with
a plain washer (5) under the bolt head and
nyloc nut. Tighten all fastenings to 20
Nm.
Figure 180: Standard roll over bar
1. Standard roll over
bar
3. Spring washer
2. Set screw
4. Plain washer
Vue de la page 205
1 2 ... 201 202 203 204 205 206 207 208 209 210 211 ... 226 227

Commentaires sur ces manuels

Pas de commentaire