Caterham Seven Manuel d'utilisateur télécharger pdf (Page 106)

Page | 105

For SV use the same procedure to fit the

primary, the sequence to fit the primary is

4,3,2,1.

58X0011A is for #1(front) cylinder.

58X0012A is for #2 cylinder.

58X0013A is for #3 cylinder

58X0014A is for #4 (rear) cylinder

When the primary pipes are in place, fit

the remaining fasteners but do not tighten

them.

Install the collector/catalyst over the

assembled primary pipes with the

threaded hole for the lambda probe faces

towards the side panel. Secure the

collector to the primary pipes with the two

springs, refer to Fig 76. Support the

weight of the collector such that the

primary pipes are not in contact with the

sides of the aperture and tighten the

primary pipe/cylinder head fasteners to 34

Nm.

Figure 76: Primary pipes and

collector/catalyst

1.Primary pipe

2.Collector/catalyst

Fit the Lambda probe into the threaded

hole in the collector/catalyst and connect

the probe plug to the corresponding

socket from the engine wiring loom.

Secure the Lambda probe connection and

wiring to the chassis ensuring that it

cannot contact the hot exhaust or any

moving part, refer to Figure 77.

NOTE

The lambda probe wiring passes under

the side of the car below the lower chassis

tube, it must not be routed through the

primary pipe aperture in the side panel.

1 2 ... 101 102 103 104 105 106 107 108 109 110 111 ... 226 227

Pas de commentaire

Caterham Seven Manuel d'utilisateur Page 106